NEC Univerge SV8100 - Page 554

Issue 1.0 UNIVERGE SV8100
2 - 530 Flexible System Numbering
11-14-13 Service Code Setup (for Hotel) –
Check-Out
Use to customize the check-out
Service Codes which are used with
the Hotel/Motel feature.
MLT, SLT
(default = 639)
3
11-14-14 Service Code Setup (for Hotel) –
Room Status Change for Own
Extension
Use to customize the room status
change for own extension Service
Codes which are used with the
Hotel/Motel feature.
MLT, SLT
(default = 640)
3
11-14-15 Service Code Setup (for Hotel) –
Room Status Change for Other
Extension
Use to customize the room status
change for other extension Service
Codes which are used with the
Hotel/Motel feature.
MLT, SLT
(default = 641)
3
11-14-16 Service Code Setup (for Hotel) –
Room Status Output
Use to customize the room status
output Service Codes which are
used with the Hotel/Motel feature.
MLT
(default = 642)
3
11-14-17 Service Code Setup (for Hotel) –
Hotel Room Monitor
Use to customize the hotel room
monitor Service Codes which are
used with the Hotel/Motel feature.
MLT, SLT
(default = 675)
3
11-14-18 Service Code Setup (for Hotel) –
Set Hotel PMS Code Restriction
Use to customize the set hotel
PMS code restriction Service
Codes which are used with the
Hotel/Motel feature.
MLT
(default = 666)
3
11-15-01 Service Code Setup,
Administrative (for Special
Access) – Remote Maintenance
Use to customize the remote
maintenance Service Codes which
are used by the administrator in
the Hotel/Motel feature.
(default = 730)
3
11-15-02 Service Code Setup,
Administrative (for Special
Access) – ACD Access in Dial-In
Conversion Table
Use to customize the ACD access
in dial-in conversion table Service
Codes which are used by the
administrator in the Hotel/Motel
feature.
(default = 760)
3
11-15-03 Service Code Setup,
Administrative (for Special
Access) – Backup Data Save
This service code is used for back
up the programmed data on the
SRAM and Call History to the
Flash ROM. While saving the
database, it may cause system
lock up.
MLT
(default =
#  # 9)
3
11-15-05 Service Code Setup,
Administrative (for Special
Access) – System Programming
Mode, Log-On
Use to customize the system
programming mode, log-on
Service Codes which are used by
the administrator in the Hotel/Motel
feature.
MLT
(default =
#  # )
3
11-15-06 Service Code Setup,
Administrative (for Special
Access) – Wake on LAN to APSU
Unit
Use to customize the wake on LAN
to APSU unit Service Codes.
MLT
(default not assigned
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3