NEC Univerge SV8100 - Page 578

Issue 1.0 UNIVERGE SV8100
2 - 554 Handset Mute
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
 Level 1 – these are the most commonly assigned programs for this feature.
 Level 2 – these are the next most commonly assigned programs for this feature.
 Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
15-07-01 Programmable Function Keys Assign a function key for Handset
Transmission Cut Off (code 40).
Line Key 1~48
0~99 (Normal Function
Code 751 by default)

00 ~

99
(Appearance Function
Code) (Service Code
752 by default)
3
80-01-01 Service Tone Setup – Repeat
Count
Customize the system basic tones
and system service tones. You
need to reset for the changes to
take affect.
0~255 (default = 0 until
On-Hook)
Refer to Table 2-14
Service Tone Setup,
Program 80-01-01 on
page 2-555
3
80-01-02 Service Tone Setup – Basic Tone
Number
The following features require that
the system tones listed below be
changed to match the table. After
changing these settings the must
be reset for the changes to take
effect.
 Call Screening
 Call Holding
 Busy Greeting
 Await Answer Transfer
1~33
(0 = No Tone)
(33=Default Time Slot)
Refer to Table 2-15
Service Tone Setup,
Program 80-01-02 on
page 2-558
3