NEC Univerge SV8100 - Page 585

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 561
Operation
To talk Handsfree:
1. Press Speaker, Trunk Line key or Virtual Extension key.
2. Place the call.
3. Speak toward the telephone when the called party answers.
To change a handset call into a Handsfree call:
1. Press Speaker and hang up the handset.
2. Press Speaker again to hang up.
To change a Handsfree call into a handset call:
1. Lift the handset.
To turn on/off Monitor:
1. Press MIC, Feature + 1, or the Microphone Function Key (Program 15-07 or SC 751 : 02) to Turns
On or off the Microphone.
 Monitor is off when MIC LED is lit, the Microphone Function Key is lit, or the handset is lifted.
20-02-12 System Options for Multiline
Telephones – Forced Intercom
Ring (ICM Call Type)
Use this option to enable (1) or
disable (0) Forced Intercom
Ringing. If enabled, incoming
Intercom calls normally ring. If
disabled, Intercom calls
voice-announce.
0 = Disable (Voice)
1 = Enable (Signal)
(default = 1)
3
20-06-01 Class of Service for Extensions Assign Class of Service (1~15) for
extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension
ports = Class 1
3
20-09-05 Class of Service Options
(Incoming Call Service) – Signal/
Voice Call
Turns Off or On an extension ability
to enable Handsfree Answerback or
Forced Intercom Ringing for their
incoming Intercom calls.
0 = Off
1 = On
(default = 1 for COS
1~15)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3