UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 569
Operation
To enable the headset:
1. Plug in the headset into the headset jack on the bottom of the telephone.
2. Program a Headset key (Program 15-07 or SC 751: 05).
You hear a confirmation beep.
To use the headset:
The Headset key lights when on a call. To disconnect, press the Headset key again.
You can still use the handset for calls or respond to voice-announced Intercom calls with the headset plugged
in. The headset only activates when the Headset key is pressed.
Answer a ringing call by pressing the Headset key.
- OR -
Press the Headset key and then a line key or press Speaker then 9 to make a outgoing call.
- OR -
Press the Headset key to get intercom dial tone.
- OR -
If on a call, press the Headset key to hang up.
20-02-05 System Options for Multiline
Telephones – Headset Busy Mode
Set the conditions under which a
headset extension is busy to
incoming callers:
The Headset extension is busy to
incoming callers when only one
extension appearance is busy (0).
- OR -
Headset extension is busy to
incoming callers only when both
extension appearances are busy
(1).
0 = No
1 = Yes
(default = 0)
3
20-02-12 System Options for Multiline
Telephones – Forced Intercom
Ring (ICM Call Type)
Determine whether intercom calls
should ring or voice-announce
extensions.
0 = Disable (Voice)
1 = Enable (Signal)
(default = 1)
3
20-09-07
Class of Service Options (Incoming
Call Service) – Call Queuing
Turns Off (0) or On (1) an extension
ability to have calls queued if a call
rings the extension when it is busy.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-13-06
Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
Allows a busy extension to Manually
(0) or Automatically (1) receive off-
hook signals.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
To Next Page
Loading...
