NEC Univerge SV8100 - Page 632

Issue 1.0 UNIVERGE SV8100
2 - 608 Intercom
Operation
To place an Intercom call:
1. At multiline terminal, press Speaker.
- OR -
At single line telephone, lift the handset.
2. Dial extension number (or 9 for your operator).
 Your call may voice-announce or ring the called extension. Dial 1 to change the way your call alerts the called
extension.
 If the extension you call is busy or does not answer, you can dial another extension without hanging up.
To answer an Intercom call:
1. If you hear two beeps, speak toward telephone.
 Your telephone picks up your voice.
- OR -
If your telephone rings, lift the handset.
To check the extension data (multiline terminal only):
1. Press the Help key.
2. Dial the extension number.
 You display shows your telephone extension number, port number and extension/Department Group.
 You can also check any other extension numbers information by pressing Help + the extension number.
3. Press Exit to return the normal time/date display.
To change how Intercom calls ring the extension:
1. Press Speaker or lift the handset.
2. Dial 723 to have calls ring your extension.
- OR -
3. Dial 721 to have calls voice announce to your extension.
Alarm Sensor Pattern
High
Mid
Low
760
760
760
760
760
760
No Change
No Change
No Change
Table 2-17 Incoming Ringing Tone
Incoming Ring Tone
Number
Tone
Type Frequency 1 Frequency 2 Modulation