NEC Univerge SV8100 - Page 651

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 627
IP Phone Configuration:
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
15-01-01 Basic Extension Data Setup –
Extension Name
Define the extension/virtual
extension name.
Up to 12 characters
Default:
STA 101 = Ext 101
STA 102 = Ext 102,
etc.
3
15-05-02 IP Telephone Terminal Basic
Data Setup – IP Phone Fixed Port
Assignment
MAC Address of registered MLT
SIP phone is stored and/or can
input the MAC address of an MLT
SIP phone so when it comes online
it will be provided with the extension
in which the MAC address matches.
MAC address
00-00-00-00-00-00 to
FF-FF-FF-FF-FF-FF
(default =
00-00-00-00-00-00)
3
15-05-07 IP Telephone Terminal Basic
Data Setup – Using IP Address
Use this program to review the
registered IP Phones IP Address
[Informational Only].
0.0.0.0 ~
255.255.255.255
(default = 0.0.0.0)
3
15-05-15 IP Telephone Terminal Basic
Data Setup – CODEC Type
Use this program to set the
registered IP Phone Codec type –
Reference Program 84-11 Dterm IP
Codec Basic Information.
1-Type 1
2-Type 2
3-Type 3
4-Type 4
5-Type 5
(default = 1)
3
15-05-16 IP Telephone Terminal Basic
Data Setup – Authentication
Password
Assign the authentication password
for SIP single line telephones.
Up to 24 characters
(default not assigned)
3
15-05-17 IP Telephone Terminal Basic
Data Setup – Calling Party
Display Info
The part of the Invite message the
calling party information is taken
from. There are four choices:
Nickname: Displays the nickname
programmed in 15-05-04.
Display Name: Some SIP phones
have a Field called “Display Name”.
If configured, in the SIP phone, this
will display upon a call from that
station.
User Part: Some SIP phones have
a field called “User Part”. If
configured in the SIP phone, this
will display upon a call from that
station.
Extension: Display shows
extension of the SIP phone.
0 = Nickname
1 = Display Name
2 = User Part
3 = Extension
(default = 0)
3