NEC Univerge SV8100 - Page 672

Issue 1.0 UNIVERGE SV8100
2 - 648 IP Trunk – H.323
10-18-01 H.323 Alias Address Setup –
Alias Address
Set the telephone number (Alias
Address) to external gatekeeper.
Dial up to 12 digits
(0~9,
, #)
(default not assigned)
3
10-18-02 H.323 Alias Address Setup –
Alias Address Type
Set the Alias Address Type to
external gatekeeper.
0 = E164
(default = 0)
3
10-23-01 SIP System Interconnection
Setup – System Interconnection
Used to determine if the system is
interconnected to another system.
0 = No (Disable)
1 = Yes (Enable)
(default = 0)
3
10-23-02 SIP System Interconnection
Setup – IP Address
Define the IP Address for the SIS
System Interconnection.
0.0.0.0 ~
126.255.255.254
128.0.0.1 ~
191.255.255.254
192.0.0.1 ~
223.255.255.254
(default = 0.0.0.0)
3
10-23-04 SIP System Interconnection
Setup – Dial Number
Define the Dial Number for the SIP
System.
Up to 12 digits (0~9)
(default not assigned)
3
10-40-01 IP Trunk Availability – IP Trunk
Availability
Use to Enable or Disable IP Trunks. 0 = Disable
1 = Enable
(default = 0)
3
10-40-02 IP Trunk Availability – Number of
Ports
Define the number of IP Trunks
when enabled.
0 ~ 128
(default = 0)
3
14-02-01 Analog Trunk Data Setup –
Signaling Type (DP/DTMF)
At default, Program 14-02-01 is set
to 2 (DTMF). For the IP trunks this
must be set for Dial Pulse [either 0
(10PPS) or 1 (20PPS)].
0=Dial Pulse (10 PPS)
1=Dial Pulse (20 PPS)
2=DTMF
(default = 2)
3
14-05-01 Trunk Group – Trunk Group
Number
Assign trunks to trunk groups then
go to Program 14-06-01 below to
set up Trunk Group Routing.
Trunks 1~200
Trunk Port 1~200,
Group 1,
Priority 1~200
3
14-06-01 Trunk Group Routing – Priority
Order Number
Used to set the priority order
number 1~4.
0 = Not Specify1~100 :
(Trunk Group
Number)1001~1100 :
(1000 + Route Table
Number)
Default:
Route 1, Order
Number 1 = 1 (Trunk
Group 1)
Order Numbers 2, 3, 4
= 0 (Not Specified)
All Other Routes
(2~100) and Order
Numbers (1~4) = 0
(Not Specified)
3
20-08-13 Class of Service Options
(Outgoing Call Service) – ISDN
CLIP
Determine if the ISDN calling line
identity presentation and screening
indicators are to be allowed.
0 = Off
1 = On
(default = 1)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3