NEC Univerge SV8100 - Page 732

Issue 1.0 UNIVERGE SV8100
2 - 708 Meet Me Conference
Meet Me Internal Conference
To make a Meet Me Internal Conference:
Multiline Terminal
1. While on a call, press Conf.
2. Dial
1 and the Combined Paging Zone code 1~8 (for Internal/External Zones 1~8) or 0 (for Internal/
External All Call).
3. Announce the zone.
4. When a co-worker answers your page, press Conf twice.
5. Repeat steps 1~4 for each co-worker you want to add.
Single Line Telephone
1. While on a call, hookflash and dial #1.
2. Dial
1 and the Combined Paging Zone code 1~8 (for Internal/External Zones 1~8) or 0 (for Internal/
External All Call).
3. Announce the zone.
4. When a co-worker answers your page, press hookflash twice.
5. Repeat steps 1~4 for each co-worker you want to add.
To join a Meet Me Internal Conference:
1. At the multiline terminal, press Speaker (or lift the handset).
- OR -
At the single line telephone, lift the handset.
2. Dial 763 (if your extension is in the zone called).
- OR -
Dial 764 and the zone number (if your extension is not in the zone called).
- OR -
Press the Meet Me Conference/Paging Pickup key (PRG 15-07 or 23) if your extension is in the
zone called.