NEC Univerge SV8100 - Page 780

Issue 1.0 UNIVERGE SV8100
2 - 756 Multiple Trunk Types
34-06-02 Add/Delete Digit for E&M Tie
Line – Additional Dial Digits
If a Tie Line network requires
additional digits to reroute the call
to a location, enter the digits for
the location which should be
added to the received digits.
Up to four digits
0~9, ,
#
(default not assigned)
3
34-07-01 E&M Tie Line Timer – First Digit
Pause (E&M Immediate Start)
Used to define the First Digit
Pause (E&M Immediate Start)
timer.
0~64800
(default = 3)
3
34-07-02 E&M Tie Line Timer – First Digit
Pause (E&M Wink Start)
Used to define the First Digit
Pause (E&M Wink Start) timer.
0~64800
(default = 0)
3
34-07-03 E&M Tie Line Timer – First Digit
Pause (LD Trunk)
Used to define the First Digit
Pause (LD Trunk) timer.
0~64800
(default = 3)
3
34-07-04 E&M Tie Line Timer – LD Trunk
Guard Time
Used to define the LD Trunk
Guard Time.
0~64800
(default = 0)
3
34-07-05 E&M Tie Line Timer – Trunk
Answer Detect Timer for E&M
Used to define the Trunk Answer
Detect Timer for E&M timer.
0~64800
(default = 30)
3
34-08-01 Toll Restriction Data for E&M Tie
Lines
Define the toll restriction data for
E&M Tie Lines if required. This
should be defined if toll restriction
is enabled in Program 21-05-13.
Up to 10 digits
(0~9, ,
#)
(default not assigned)
3
80-03-01 DTMF Tone Receiver Setup –
Detect Level
Use Items 11~32 to set the criteria
for dial tone detection for outgoing
ARS calls.
0 = 0dBm ~ -25dBm
1 = -5dBm ~ -30dBm
2 = -10dBm ~ -35dBm
3 = -15dBm ~ -40dBm
4 = -20dBm ~ -45dBm
5 = -25dBm ~ -50dBm
6 = -30dBm ~ -55dBm
default: Type 1~5 = 0
3
80-03-02 DTMF Tone Receiver Setup –
Start Delay Time
Use this option to define the start
delay time for DTMF Tone
Receiver.
0~255
(0.25 ms ~ 64 ms)
default: Type 1~5 = 0
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3