NEC Univerge SV8100 - Page 810

Issue 1.0 UNIVERGE SV8100
2 - 786 Off-Hook Signaling
 Block Camp-On
If an extension has Block Camp-On enabled, callers to the extension cannot dial 2 to Camp-On after
hearing busy or busy/ring. If the extension has Block Camp-On disabled, callers are not prevented
from dialing 2 to Camp-On after hearing busy or busy/ring. This is set in the called extension Class
of Service.
Conditions
 An extension user cannot Camp-On to a busy extension or leave a callback if Off-Hook
Signaling has already gone through. Off-Hook Signaling allows an extension to block a
caller’s ability to dial
# to camp-on.
 You cannot send off-hook signals to an extension busy on a Handsfree (Speakerphone) call.
The called extension large LED flashes fast, with no ringing.
 The setting of Program 20-13-06 affects the BLF display for Hotline and Reverse Voice
Over. Refer to Hotline and Reverse Voice Over features for additional information.
 You cannot send off-hook signals to an extension that is already receiving a voice
announcement.
 An extension user can store the Off-Hook Signaling Service Code (709) under a One-Touch
Key to provide quick Off-Hook Signaling access.
 An extension set as Operator in Program 20-17-01 does not follow settings in Program
20-13-05, Program 20-13-06 or Program 20-09-07 and always receives Off-Hook Signaling.
 Program 20-09-07 and 20-13-06 must be set to 1 in Class of Service for a normal extension
to receive automatic Off-Hook Signaling.
 Off-Hook signaling is not supported for Wireless DECT (SIP) telephones.
Default Setting
Enabled
System Availability
Terminals
All Multiline and Single Line Terminals
Required Component(s)
None