Issue 1.0 UNIVERGE SV8100
2 - 834 PC Programming
Conditions
The hardware/software requirements for the host PC running the PCPro application are:
The hardware/software requirements for the host PC running WebPro are:
You can have a maximum of four users logged into WebPro anytime.
You can have up to two phones in programming mode anytime.
You can have four WebPro users and two phone programming users logged in all at the
same time for a total of six users in programming mode simultaneously. However, the two
phone programming users do not show up in session management in WebPro.
PCPro can be logged in with only one user. This is allowed only if no other users are logged
into programming mode (PCPro, WebPro, or Phone). Also, if a user is connected to the
switch via PCPro, no other user can log in through PCPro, WebPro, or Phone Programming.
Item Requirement
CPU
Pentium
®
III 598MHz (minimum)
Pentium 4 2.5GHz (recommended)
Memory 128 MB of RAM, 256 MB (recommended)
Operating System (OS) MS Windows 2000
Windows XP or Microsoft Vista
Other Microsoft Internet Explorer 6.0 or higher
Communication Port LAN, or Modem
Disk Space 35MB for PCPro (minimum)
TCP Port TCP port 8000 must be open between the terminal and
the host PC for uploading/downloading via LAN. PCPro/
WebPro TCP port is set for 8000 at default, but can be
changed via WebPro using PRG 90-38-02. PRG 90-38-
02 is not accessible from Phone Programming or PCPro.
TCP port 5963 is required to be open if the Debug
Terminal is going to be used.
Screen Resolution 800 x 600 (minimum)
1024 x 760 (recommended)
Item Requirement
Browser MS Internet Explorer 6.0 (or higher)
Mozilla Firefox 1.0.3 (or higher)
Network IP connection to the KTS
Screen Resolution 800 x 600 (minimum)
1024 x 760 (recommended)
To Next Page
Loading...
