NEC Univerge SV8100 - Page 882

Issue 1.0 UNIVERGE SV8100
2 - 858 Programmable Function Keys
 If the feature key is not listed below, the LCD shows ALL-BLANK. (Program 15-07-01 Line
Key Assign).
 One-Touch keys programmed for Park Hold Service Code cannot be used to park calls
without using Hold or Transfer.
 Pauses can be entered in the dial string of a DSS/One Touch button. The pause is entered
as P in the dial string and causes the system to wait three seconds before sending the rest of
the digits that follow the P (pause). Multiple pauses can be entered.
 The @ can be entered in the dial string of a DSS/One Touch button. The @ only applies to
ISDN and Intercom calls. When using the @, the system waits for the destination to answer
(answer supervision), and then sends the rest of the digits.
 Entering a P (pause) in a DSS/One Touch dial string can be used for CO calls, Intercom
calls, or after the @ for ISDN calls.
 DSS/One-Touch keys can be used for one-touch transfer.
 DSS keys can distinguish whether the telephone is set for DND/Call Forward All Calls of if
the telephone is off-hook.
 When a Ring Group call rings a station, a BLF Indication for this station shows idle or busy
based on Class of Service option (20-13-49).
 All features programmed under one touch keys are still subject to class of service
restrictions.
 If you change the extension assigned to a port in Program 11-02, the line key programming
does not follow. However, if you move the extension using the Station Relocation Feature,
the line key programming does follow.
 In order for a station to retrieve a held ICM call, the station must have an ICM key assigned
in 15-07 (

00).
Function
Number
Function Display
00 None [All Blank]
01 DSS/One-Touch DSS (xxxxxxxx xxxxxxxx = Extension Number
02 Microphone Key (ON/OFF) MIC
03 DND Key DND
04 BGM (ON/OFF) BGM
05 Headset HSET
07 Conference Key CONF
10 Call Forward – Immediate CFA
11 Call Forward – Busy CFB
12 Call Forward – No Answer CFNA
13 Call Forward – Busy/No Answer CFBNA
14 Call Forward – Both Ring CFBOTH
15 Follow Me FLWME
 If a key is programmed as a DSS/One-Touch key for a station that is set for Call Forward All Calls or Do Not
Disturb, the DSS/One-Touch key flashes.
 Refer to the UNIVERGE SV8100 Programming Manual for a complete list of Function Numbers.