Issue 1.0 UNIVERGE SV8100
2 - 868 Pulse to Tone Conversion
Related Features
Central Office Calls, Placing
Multiple Trunk Types
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Operation
To convert your telephone dialing to tone after placing your call on a pulse line:
1. Place a call over pulse line.
2. Dial
# to switch the DP trunk to DTMF dialing.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
14-02-01 Analog Trunk Data setup –
Signaling Type (DP/DTMF)
At default, Program 14-02-01 is set
to 2 (DTMF).
0=Dial Pulse (10 PPS)
1=Dial Pulse (20 PPS)
2=DTMF
(default = 2)
3
14-02-07 Analog Trunk Data Setup – DP to
DTMF Conversion Options
For each trunk, set the type of DP
to DTMF Conversion required:
automatic (0), automatic and
manual (1), or manual (2).
0 = Automatic
1 = Automatic and
Manual
2 = Manual
(default = 2)
3
To Next Page
Loading...
