UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 971
To store a Station Speed Dialing number (display telephones only):
1. Press Speaker.
2. Dial 755.
3. Dial the Station Speed Dial buffer number to be programmed (0~9).
1 = Station Speed Dial buffer 1
2 = Station Speed Dial buffer 2
" " " " " "
0 = Station Speed Dial buffer 10
4. Dial the telephone number you want to store (up to 24 digits).
Valid entries are 0~9, # and . To enter a pause, press MIC. To store a Flash, press Recall.
5. Press Hold.
6. Enter the name associated with the Speed Dialing number (display telephones only).
7. Press Hold.
8. Press Speaker to hang up.
Key for Entering Names
Use this keypad
digit . . .
When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
→ ← Á À Â Ã Ç É Ê ì ó
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters:
0 ! “ # $ % & ’ ( ) ô
Õ ú ä ö ü α ε θ
Enter characters:
+ , - . / : ; < = > ? π Σ σ Ω ¢ £
#
# = Accepts an entry (only required if two letters on the same key are needed – ex: TOM).
Pressing # again = Space.
Conf Clears the character entry one character at a time (used when entering the name).
Exit Clears all the entries from the point of the flashing cursor and to the right (used when entering
the number, this clears both the number and name).
To Next Page
Loading...
