Chapter 4 Standard Mode
4-65 NWA-033628-001 Rev.1.0
[Upgrade] Category
STEP6: When the upgrade status is 2 or 4 in the table on step 5, follow processes.
- Upgrade status is 2:
Assign the command data for the appropriate blade except for CM05 Y=0 data.
- Upgrade status is 4:
Mount the blade and perform step 4 and 5 again after time-out period is elapsed (approximate-
ly 3 minutes [depends on the file size] later after the upgrade start)
This is the end of the procedure for firmware program upgrade.
Upgrade Status
Confirmation Method
Blade Lamp
Indication
CME8 Y=2 CME8 Y=0
4 Abnormal end under
upgrading
RUN lamp is
undefined
(such as OFF, ON)
F00F Firmware version is
not changed
5 Under normal opera-
tion after upgrade
(after reset)
RUN lamp
(flash)
00FF Firmware version is
changed
To Next Page
Loading...
