Chapter 4 Standard Mode
4-71 NWA-033628-001 Rev.1.0
[Maintenance] Category
[Maintenance] Category
The [Maintenance] Category is organized into the following five submenus:
• System Configuration Display Page 4-71
• Status Display (Blade/Trunk) Page 4-74
• Fault Display Page 4-79
• System Data Save/Load/Verify Page 4-81
• Reset Page 4-92
System Configuration Display
The [System Configuration Display] reads system configuration and blade information, and detailed Port
information from the SV8300 and presents the information in HTML format. Work in the following steps:
NOTE: Establish a communication link with the SV8300 to view system configuration information
For how to establish a communication link, refer “Establishing a Link”. Page 2-12
STEP1: Take one of these actions:
• Click submenu [System Configuration Display] in Standard Mode.
• On the Main Menu, click [System] > [Maintenance] > [System Configuration Display] in this
order.
The [System Configuration Display] screen is displayed in the work window.
• To edit the read out information from the SV8300: Go to Step 2.
• To leave the read out information from the SV8300 unchanged: Go to Step 5.
(1)
(2)
[System Configuration
Display] menu
(4)
(3)
To Next Page
Loading...
