Chapter 6 Command Mode
6-12 NWA-033628-001 Rev.1.0
Using Command Mode
Trace Information
The [Trace] menu confirms trace information that is transmitted from the SV8300 randomly.
One of the following action will display a [Trace Information] screen in the work window:
• Click submenu [Trace Information] in Command Mode.
• On the Main Menu, click [System] > [Maintenance] > [Trace Information] in this order.
NOTE 1: To perform the Trace Information, setting of system data (CMF6) is required in advance.
NOTE 2: This menu is reserved for NEC technicians and need not be used in most situations.
(1)
(2)
(4)
(5)
(3)
(6)
To Next Page
Loading...
