Chapter 4 Standard Mode
4-6 NWA-033628-001 Rev.1.0
[Implement] Category
NOTE 1: System data that has been configured through the button [2] to [7] button screens is not applied
to the SV8300 until a write operation is performed in the screen invoked by clicking the [Com-
pletion] button.
NOTE 2: For a detailed description of item settings, refer to the “Command Manual”.
Button
name
Setup item Description Refer
[1] All-Clear of System
Data (CM00/CMEC)
Clears all system data on the SV8300. Page 4-7
[2] Setting of Date/
Time and Language
(CM02/CM04)
Sets the Date & Time and the language used
on the SV8300.
Page 4-9
[3] Setting of IP Address
(CM0B)
Sets the IP addresses of the SV8300 and the
RTP port (VoIPDB blade).
Page 4-10
[4] Setting of Numbering
Plan (CM20)
Sets a numbering plan for the station and the
trunk route access.
Page 4-12
[5] Setting of Station
(CM05/CM10/CM12/
CM77)
Registers a LC/DLC blade and sets a station
number and relevant data.
Page 4-14
[6] Setting of IP Station
(CM10/CM12/CM77)
Configures IP Station. Page 4-17
[7] Setting of Trunk
(CM05/CM10/CM30)
Registers a trunk blade and sets trunk data. Page 4-20
[Completion] Setting the system data
to System
Writes the system data configured through
the screen to the SV8300.
Page 4-24
To Next Page
Loading...
