Chapter 4 Standard Mode
4-8 NWA-033628-001 Rev.1.0
[Implement] Category
STEP6: Click [Clear All System Data] button.
A dialog box is displayed, asking you to confirm the execution of System Data All Clear.
STEP7: Confirm the [SENSE] switch on the CPU blade is set on “E” and click the [Yes] button.
After a while, the RUN lamp of CPU blade light off at the completion of Clear All System
Data, accompanied by the appearance of a dialog box indicating its completion.
STEP8: Click the [OK] button.
You are directed back to the [Quick Setup] dialog box. Checked mark appears to the right of
button [1].
[Clear All System Data]
button
[Yes] button
[OK] button
To Next Page
Loading...
