NEC Univerge SV8300 - Page 57

Chapter 4 Standard Mode
4-11 NWA-033628-001 Rev.1.0
[Implement] Category
STEP2: Set items (1) to (3) for the SV8300 (CPU blade) and RTP (VoIPDB blade).
Continued on next page
No. Item Description
(1) IP Address field Enter the IP addresses of the SV8300 maintenance port and VOIP port
(UDP/TCP).
• 0.0.0.1 to 255.255.255.254
(default: 192.168.1.1 [maintenance port]/172.16.1.1 [VOIP port])
(2) Subnet Mask field Enter the subnet masks of the SV8300 maintenance port and VOIP
port.
• 255.0.0.0 to 255.255.255.252
(default: 192.255.255.0 [maintenance port]/255.255.0.0 [VOIP port])
• Make sure that subnet mask of the maintenance port and VOIP port
are not the same.
(3) Default Gateway
field
Enter the default gateways of the SV8300 maintenance port and VOIP
port.
• 0.0.0.1 to 255.255.255.254 (default: blank)
(4) RTP Channel Count
selection field
Select the number of RTP channels used on the VoIPDB blade from a
dropdown list for display.
• Selection range: 016 to 128 (in groups of 16 channels)
(default: all channels on the mounted blade 64/128)
[OK] button
(1)
(1)
(4)
(5)
(2)
(2)
(7)
(3)
(6)
(3)