Chapter 4 Standard Mode
4-33 NWA-033628-001 Rev.1.0
[Implement] Category
STEP11: Click the [Apply] button.
The settings are written to the SV8300, and you are directed back to the [Blade Configura-
tion] screen. The slots in which additional blades are mounted are checked.
The following dialog boxes are displayed in accordance with the assigned blade after click-
ing the [Apply] button, then click the [Yes] button.
• LC/LLC/DLC/COT/DID/LD/OD/CSI
• PRT/DTI/CCT/QSIG
•BRT/ILC
Additional blades have now been registered.
[Yes] button
[Yes] button
[Yes] button
To Next Page
Loading...
