SWINGER SHUTDOWN
Limits the number of calls made by a zone alarm in any one armed period.
Alarm reports are normally limited to 15 multiple reports per zone.
When Swinger Shutdown is enabled, multiple reports are reduced to 3 multiple reports
per zone.
PROGRAMMING SEQUENCE:
P89E 4E toggles the option ON and OFF
OFF: Swinger Shutdown is 15 reports per zone)
ON: Swinger Shutdown is 3 reports per zone)
P89E 4E
PROGRAM MODE LEVEL
Installer, Remote by PC.
FACTORY DEFAULT
ON.
NOTES
This prevents unnecessary multiple
alarms reported to the Central station
in cases, for example, where a door is
‘swinging’ in the wind.
This option only applies to zones enabled
to Report Multiple Zone Alarms.
RELATED OPTIONS
P78E Report Multiple Zone Alarms.
LINE FAIL MONITOR
This option enables the Line Fail monitor which periodically (20secs) tests the
telephone line. If the telephone line is not found the Line light starts flashing. If the line
fault continues for 2 minutes then the keypad beeps a warning and Aux2 is turned ON
if that option is selected.
PROGRAMMING SEQUENCE:
P89E 5E toggles the option ON and OFF
OFF: No Line Fail Monitor
ON: Line Fault Monitor enabled
P89E 5E
PROGRAM MODE LEVEL
Installer, Remote by PC.
FACTORY DEFAULT
OFF.
RELATED OPTIONS
P66E 5E Aux2 is Line Fail Output
INTERNAL TIMING
When set ON, the Test Report Timer uses the panel’s onboard crystal oscillator instead
of the external mains power supply frequency.
Use this option if the mains frequency is not stable over long periods. (Not necessary
in Australia and New Zealand).
PROGRAMMING SEQUENCE:
P89E 7E toggles the option ON and OFF
OFF: Clock uses mains frequency timing
ON: Clock uses internal timing
P89E 7E
PROGRAM MODE LEVEL
Installer, Remote by PC.
FACTORY DEFAULT
OFF.
43
Ness eCO8x CONtrOl PaNel – INstallatION MaNual
P R O G R A M M I N G
To Next Page
