Netgate FXS Series - Chapter 24 Command List; Hyper Terminal Setting; Figure 24-1 Connection Description

Command with FXS Gateway
- 122 -
Chapter 24
Command List
This section introduces the command line interface and lists all of the command
s.
24.1 Hyper Terminal Setting
A terminal emulator is needed when using RS-232 port to configure Gateway.
There are kinds of terminal emulator software. Here, we use Microsoft HyperTerminal
to depict how to set up terminal emulator:
Step 1. Execute the Hyper Terminal program, and then the following windows will
pop-up on the screen (STARTÆProgram filesÆAccessoriesÆ Communication
ÆHyper Terminal).
Figure 24-1 Connection Description
Step 2. Define a name such as [FXS-02A] for this new connection, after pressing [OK]
button.