FXS Gateway Overview
- 22 -
Protocol should now be on the list of installed network components.
Step 7. Click the [Properties] button. The TCP/IP Properties windows consist of
several tabs. Choose the [IP Address] tab.
Step 8. Select [Specify an IP Address] and enter [10.1.1.1] in the [IP Address]
location (where xxx is a number between 2 and 254 used by the VoIP Gateway to
identify each computer), and the default [Subnet Mask: 255.0.0.0]. Note than no
two computers on the same LAN can have the same IP address.
Step 9. Click on the [DNS Configuration] tab and select [Enable DNS]. Then click the
[Add] button.
Step 10. Click on the [Gateway] tab and enter the High-Performance VoIP Gateway
default gateway value 10.1.1.254 in the [new gateway] field, then click [Add]
Button.
Step 11. Click [OK] button, Restart your PC to complete the TCP/IP installation.
1.9 Power Up Your VoIP Gateway
At this point, you should have connected the console port, the LAN Port, the WAN
port and the power port to the appropriate devices or lines. Plug the power adapter into
a wall outlet. The Power LED should be on. The Status LED will come on after the
system tests are complete. The WAN LED and one of the LAN LEDs come on
immediately after the Status LED come on, if connections have been made to the LAN
To Next Page
Loading...
