FXS Gateway Overview
- 20 -
1.7 Additional Installation Requirements
In addition to the contents of your package, there are other hardware and
software requirements you need before you can install and use your VoIP Gateway.
These requirements include:
1. A computer with an Ethernet NIC (Network Interface Card) installed.
2. A computer equipped with communications software configured to the following
parameters:
VT100 terminal emulation.
9600 Baud.
No parity, 8 Data bits, 1 stop bit, Flow Control set to None.
3. Use Internet Explorer 5.5 and later or Netscape Navigator 6 and later versions.
4. Analog telephone set
5. Software tools: Gatekeeper (optional)
After the VoIP Gateway is properly set up, you can make future changes to the
configuration through telnet connections
1.8 Setting Up the TCP/IP Protocol
If you are not sure whether the TCP/IP Protocol has been installed, follow these
setups to check, and if necessary, install TCP/IP onto your PCs.
Step 1. Click the [Start] button, Choose [Settings], then [Control Panel]. Double-click
To Next Page
Loading...
