Netgate FXS Series - Figure 24-8 Quit Commend

Command with FXS Gateway
- 161 -
Welcome to Terminal Configuration Mode
Please enter your configuration item
usr/config$
Figure 24-8 quit commend
Note:
It is recommended that type the [quit] command before you leave the console. If
so, Gateway will ask password again when next user connects to console port.
24.7.2 [debug]
Open debug message will show up specific information while Gateway is in
operation. After executing the debug command, it should execute command
[debug –open] as well.
usr/config$ debug
Debug message information and configuration
Usage:
debug [-add type1 [[type2]..]] | -open | -close | -status