Command with FXS Gateway
- 158 -
usr/config$ setmac
- enter mac address (xxxxxxxxxxxx):0001a8002743
- the mac address is 00 01 a8 00 27 43
- if mac address is correct,please press 'y' to
setup configuration,else press 'n' to continue
y
- mac address configuraton OK.
usr/config$
Step 5. Set IP Address:
usr/config$ ifaddr –ip xxx.xxx.xxx.xxx –mask xxx.xxx.xxx.xxx –gate
xxx.xxx.xxx.xxx
Step 6. commit, reboot
usr/config$ commit
usr/config$ reboot
24.6 Commands with Gateway
The following table lists all of the commands that you can use with the Gateway.
Refer to the following chapters for descriptions of commonly used commands.
This user’s guide describes commands that are helpful for configuring the Gateway.
To Next Page
Loading...
