Netgate FXS Series - Power up Your Gateway; Figure 24-4 Com Properties

Command with FXS Gateway
- 124 -
Figure 24-4 Com Properties
24.2 Power Up Your Gateway
At this point, you should have connected the console port, the LAN Port, the WAN
port and the power port to the appropriate devices or lines. Plug the power adapter into
a wall outlet. The Power LED should be on. The [Status LED] will come on after the
system tests are complete. The WAN LED and one of the LAN LED come on
immediately after the [Status LED] come on, if connections have been made to the
LAN and WAN ports.
¾ Initial Screen
When you power on your Gateway it performs server internal tests as well as line
initialization.
After the tests, the Gateway asks you to enter the Login, as shown.
....Attached TCP/IP interface to cpm unit 0