Netgate FXS Series - Figure 24-35 Phone Commend List

Command with FXS Gateway
- 213 -
phone -flash 100 300
usr/config$
Figure 24-35 phone commend list
Parameter Usages:
-print: Print current call progress tone configurations (ring: ring tone, rbt: ring back tone,
bt: busy tone, dt: dial tone). This parameter should be accompanied with tone
type.
-ring: To set RING tone value. The played tone type, when Gateway is receiving a call.
-rbt: To set RingBackTone value. The played tone type, when Gateway receives a
Q.931 Alerting message. In condition that Gateway is the originate side.
-bt: To set BusyTone value. The played tone type, when destination is busy.
-dt: To set DialTone value. The played tone type, when hook off a phone set of
workable Gateway.
-flash: Set the detective flash range in ms, for example, 300-500 ms.
Note:
For tone simulation, Gateway adopts dual frequencies as traditional telephone