Netgate FXS Series - Figure 24-24 Line Commend List

Command with FXS Gateway
- 190 -
hunt: Hunting group.
hotline: Hot line configuration.
forward: No answer forward for FXS line.
Example:
line -config 1 hunt 1 hotline 1003 forward 1002
usr/config$
Figure 24-24 line commend list
Parameter Usages:
-print: print out all current settings of line
-config: determine which line to configure
--hunt: Set hunting group flag of each line. User can assign different hunt
group number represent different hunt group.
--hotline: Set hotline table. The Hotline Mode is applied in limited two
channels. User just picks up the phone set of one FXS TEL or calls
in one FXO line, and gateway will automatically dial out a phone
number. In the other hand, user will hear ring back tone or dial tone
immediately depended on configurations of destination device.