Virtual Private Networking
107
N600 Wireless Dual Band Gigabit VDSL2 Modem Router DGND3800B
The computer has to have the NETGEAR ProSafe VPN Client program installed, which
supports IPSec. Go to the NETGEAR website (http://www.netgear.com) for information about
how to purchase the NETGEAR ProSafe VPN client.
Note: Before installing the NETGEAR ProSafe VPN Client software, be
sure to turn off any virus protection or firewall software you might be
running on your computer. You might need to insert your Windows
CD to complete the installation.
To configure the NETGEAR ProSafe VPN client:
1. Install the NETGEAR ProSafe VPN client on the remote computer, and then reboot.
a. Install the IPSec component. You might have the option to install either the VPN
adapter or the IPSec component or both. The VPN adapter is not necessary.
If you do not have a modem or dial-up adapter installed in your computer, you might
see the warning message stating, “The NETGEAR ProSafe VPN Component requires
at least one dial-up adapter be installed.” You can disregard this message.
b. Reboot the remote computer.
The ProSafe icon (
) is in the system tray.
c. Double-click the ProSafe icon to open the Security Policy Editor.
2. Add a new connection.
a. Run the NETGEAR ProSafe Security Policy Editor program, and, using Table 5 on
page 104, create a VPN connection.
b. From the Edit menu of the Security Policy Editor, select Add, and then click
Connection.
A New Connection listing appears in the list of policies.
To Next Page
Loading...
Need help?
General
