Advanced Settings
88
N600 Wireless Dual Band Gigabit VDSL2 Modem Router DGND3800B
• Enable Wireless Repeating Function. Select this check box if you want to use the
wireless repeating function.
• Disable Wireless Client Association. If your modem router is the repeater, selecting
this check box means that wireless clients cannot associate with it. Only LAN client
associations are allowed.
- If you are setting up a point-to-point bridge, select this check box.
- If you want all client traffic to go through the other access point (repeater with wireless
client association), leave this check box cleared.
• Wireless MAC of this router. This field displays the MAC address for your modem router
for your reference. You will need to enter this MAC address in the corresponding Wireless
Repeating Function screen of the other access point you are using.
• Wireless Repeater. If your modem router is the repeater, select this check box.
• Repeater IP Address. If your modem router is the repeater, enter the IP address of the
other access point.
• Base Station MAC Address. If your modem router is the repeater, enter the MAC
address for the access point that is the base station.
• Wireless Base Station. If your modem router is the base station, select this check box.
• Disable Wireless Client Association. If your modem router is the base station, selecting
this check box means that wireless clients cannot associate with it. Only LAN client
associations are allowed.
• Repeater MAC Address (1 through 4). If your modem router is the base station, it can
act as the “parent” of up to 4 other access points. Enter the MAC addresses of the other
access points in these fields.
Set Up a Point-to-Point Bridge
In point-to-point bridge mode, the modem router communicates as an access point with
another bridge-mode wireless station. As a bridge, wireless client associations are disabled.
To Next Page
Loading...
Need help?
General
