Virtual Private Networking
112
N600 Wireless Dual Band Gigabit VDSL2 Modem Router DGND3800B
remote computer has a dynamically assigned WAN IP address, it has to initiate the
request.
To perform a ping test using our example, start from the remote computer:
a. Establish an Internet connection from the computer.
b. On the Windows taskbar, click the Start button, and then select Run.
c. Type ping -t 192.168.3.1, and then click OK.
This causes a continuous ping to be sent to the first modem router. After between
several seconds and 2 minutes, the ping response should change from timed out
to reply.
Once the connection is established, you can open a browser on the computer and enter
the LAN IP address of the remote gateway. After a short wait, you should see the login
screen of the modem router (unless another computer is already logged in to the modem
router).
You can view information about the progress and status of the VPN client connection by
opening the NETGEAR ProSafe Log Viewer.
To Next Page
Loading...
Need help?
General
