VPN Configuration
159
N600 Wireless Dual Band Gigabit VDSL2 Modem Router DGND3800B
Note: In this example, the connection name on the client side of the VPN
tunnel is toGW_A. It does not have to match the VPN_client connection name
used on the gateway side of the VPN tunnel because connection names do not
affect how the VPN tunnel functions.
d. In the Connection Security section, select Secure.
toGW_A
e. In the ID Type drop-down list, select IP Subnet.
f. In this example, in the Subnet field, type 192.168.0.1 as the network address of the
modem router.
g. In the Mask field, enter 255.255.255.0 as the LAN subnet mask of the modem
router.
h. In the Protocol drop-down list, select All to allow all traffic through the VPN tunnel.
i. Select the Connect using Secure Gateway Tunnel check box.
j. In the ID Type drop-down list, select Domain Name, and enter fromGW_A.com (in
this example).
k. Select Gateway Hostname and enter ntgr.dyndns.org (in this example).
3. Configure the security policy in the modem router software.
To Next Page
Loading...
