Wireless Settings
34
N600 Wireless Dual Band Gigabit VDSL2 Modem Router DGND3800B
WPS (Push 'N' Connect) Method
If your wireless device supports WPS (Push 'N' Connect), follow these steps:
1. Press the WPS button on the router front panel
.
2. Within 2 minutes, press the WPS button on your wireless device, or follow the WPS
instructions that came with the device. The device is now connected to your router.
3. Repeat steps 1–2 to add other WPS wireless devices.
Router Interface Method
To add clients (devices) using the router interface:
1. Select Add WPS Client at the top of the router menus. If you cannot select Add WPS
Client, select Setup > Wireless Settings and make sure that WPS is selected.
2. Click Next. The following screen lets you select the method for adding the WPS client.
3. Select either Push Button or PIN Number. With either method, the client wireless device
attempts to detect the WPS signal from the modem router and establish a wireless
connection in the time allotted.
The PIN method displays this screen so you can enter the client security PIN number:
• While the modem router attempts to connect to a WPS-capable device, the WPS LED
on the front of the modem router blinks green. When the modem router establishes a
WPS connection, the LED is solid green.
• If a connection is established, the modem router WPS screen displays a confirmation
message.
4. Repeat to add another WPS client to your network.
To Next Page
Loading...
Need help?
General
