Content Filtering
48
N600 Wireless Dual Band Gigabit VDSL2 Modem Router DGND3800B
To set up port triggering:
1. Select Content Filtering > Port Forwarding/Port Triggering to display the following
screen:
2. Select the Port Triggering radio button to display the port triggering information.
3. Clear the Disable Port Triggering check box.
Note: If the Disable Port Triggering check box is selected after you
configure port triggering, port triggering is disabled. However, any
port triggering configuration information you added to the router is
retained even though it is not used.
4. In the Port Triggering Timeout field, enter a value up to 9999 minutes. This value controls the
inactivity timer for the designated inbound ports. The inbound ports close when the inactivity
time expires. This is required because the router cannot be sure when the application has
terminated.
5. Click Add Service.
6. In the Service Name field, type a descriptive service name.
To Next Page
Loading...
Need help?
General
