Security
81
R6300v2 Smart WiFi Router
Note: If you use applications such as multiplayer gaming, peer-to-peer
connections, real-time communications such as instant messaging, or
remote assistance (a feature in Windows XP), you should also enable
Universal Plug and Play (UPnP). See Universal Plug and Play on
page 109.
To configure port triggering, you need to know which inbound ports the application needs,
and the number of the outbound port that will trigger the opening of the inbound ports.
You
can usually determine this information by contacting the publisher of the application or user
groups or news groups.
To enable port triggering:
1. Select ADV
ANCED > Advanced Setup > Port Forwarding/Port Triggering.
2. Select the Port T
riggering radio button.
3. Clear the Disable Port Triggering check box.
Note: If the Disable Port Triggering check box is selected after you
configure port triggering, port triggering is disabled. However, any port
triggering configuration information you added to the router is retained
even though it is not used.
4. In the Port
Triggering Timeout field, enter a value up to 9999 minutes.
This value controls the inactivity timer for the designated inbound ports. The inbound
ports close when the inactivity time expires.
This timeout is required because the router
cannot detect when the application has terminated.
To add a port triggering service:
1. Select ADV
ANCED > Advanced Setup > Port Forwarding/Port Triggering.
2. Select the Port T
riggering radio button
To Next Page
Loading...
Need help?
General
