NETGEAR R6300v2 User Manual

Security
82
R6300v2 Smart WiFi Router
3. Click the Add Service button.
4. In the Service Name field, type a descriptive service name.
5. In the Service User list, select Any, or select Single address and enter the IP address of
one computer
.
• Any (the default), allows any computer on the Internet to use this service.
• Single address restricts the service to a particular computer
.
6. Select the service type, either TCP or UDP or TCP/UDP (both). If you are not sure, select
TCP/UDP
.
7. In the
Triggering Port field, enter the number of the outbound traffic port that will open the
inbound ports.
8. Enter the inbound connection port information in the Connection
Type, Starting Port, and
Ending Port fields.
9. Click the Apply button.
The service appears in the Port Triggering Portmap table.
10. Make sure that you enable port triggering so that the service that you added will be used.

NETGEAR R6300v2 Specifications

General

WiFi Technology	802.11ac Dual Band Gigabit
WiFi Range	Medium to large homes
USB Ports	1 x USB 3.0, 1 x USB 2.0
Wireless Standard	802.11a/b/g/n/ac
Frequency Band	2.4 GHz and 5 GHz
Processor	800 MHz
Ethernet Ports	4 x Gigabit LAN, 1 x Gigabit WAN
Antenna	3 external antennas
Security	WPA/WPA2-PSK
Ports	1x WAN, 4x LAN, 1x USB 3.0, 1x USB 2.0
Memory	256 MB RAM, 128 MB Flash
WiFi Speed	Up to 1750 Mbps (450 Mbps on 2.4 GHz + 1300 Mbps on 5 GHz)