3. Enter the AP login password and click the LOGIN button.
The AP login password is the one that you specified the first time you logged in to
the AP. The password is case-sensitive.
The Dashboard page displays.
4. Select Management > Management > Advanced.
The page that displays shows the UPnP Settings section and the Email Alert section.
5.
In the Email Alert section, configure the following settings:
a. Select the Status Enable check box.
The fields and menus become available.
b.
In the From field, enter the originating email address.
c.
In the To field, enter the email address of the recipient.
d.
In the Subject field, enter the subject information of the email or leave the default
subject information.
The default subject information depends on the model number (WAX214v2) and
MAC address of the AP’s LAN interface (XX:XX:XX:XX:XX:XX in the following
example):
[Email-Alert][WAX214v2][XX:XX:XX:XX:XX:XX] Configuration Changed
e.
In the Username field, enter the user name to access the originating email
account.
f. In the Password field, enter the password to access the originating email account.
g.
In the SMTP Server field, enter the name of the outgoing email server name.
h.
In the Port field, enter the port number that the AP uses to contact the SMTP
server.
By default, the port number is 25.
i.
From the Security Mode menu, select one of the following options, depending
on the security that the SMPT server uses:
•
None: The SMTP server does not use security. This is the default setting.
•
SSL/TLS: The SMTP server uses the SSL or TLS security protocol
•
STARTTLS: The SMTP server uses the STARTTLS security protocol.
6. To send a test email, click the Send Test Mail button.
7.
Verify that the recipient receives the email.
8. Click the Apply button.
Your settings are saved.
User Manual107Monitor the AP and its Network
Connections
Essentials WiFi 6 AX1800 Dual Band Access Point Model WAX214v2
To Next Page
Loading...
