Factory default settings
You can reset the AP to the factory default settings, which are shown in the following
table.
For information about resetting the AP to its factory settings, see Reset the AP to factory
default settings on page 91.
Table 9. Factory default settings
Default SettingFeature
Access
https://www.aplogin.netDomain name
https://192.168.0.100Default IP address
Enabled.
Note: If connected to a network, the AP receives an IP address from a DHCP server
or router in the network.
DHCP client
No default password. The first time that you log in to the device UI, you must define
an AP login password that applies only to device UI access.
AP login password
Disabled (untagged)Management VLAN
Management WiFi network
WAX214v2XXXXXX-CONFIG-ONLY
XXXXXX represents the last six characters of the MAC address of the AP’s LAN
interface.
SSID (WiFi network name)
The unique WiFi password is printed on the AP label. The security is WPA2-Personal.WiFi password for the
management WiFi network
Automatically turns off after15 minutes of being idle.Time-out period for the
management WiFi network
User WiFi networks
By default, the first user WiFi network is enabled after you specify the name and
WiFi password the first time that you log in to the device UI.
The second, third, and fourth SSIDs are disabled by default:
NETGEARXXXXXX_2
NETGEARXXXXXX_3
NETGEARXXXXXX_4
XXXXXX represents the last six characters of the MAC address of the AP’s LAN
interface. When you enable one of these user WiFi networks, the default WiFi
password is sharedsecret and the default security is WPA2-Personal.
SSID (WiFi network names)
The address range is the same range from which the DHCP server (or router) in your
network assigns addresses.
DHCP IP address range for
WiFi client assignment
User Manual124Factory Default Settings and
Technical Specifications
Essentials WiFi 6 AX1800 Dual Band Access Point Model WAX214v2
To Next Page
Loading...
