Table 9. Factory default settings (Continued)
Default SettingFeature
The address range is derived from the range of the DHCP server (or router) in your
network, but it is not the same range.
DHCP IP address range for
guest WiFi client
assignment
Settings for each individual user WiFi network
DisabledGuest network
DisabledHidden SSID
DisabledClient isolation
DisabledVLAN isolation
DisabledL2 isolation
DisabledFast roaming
DisabledWiFi MAC filter
Non assignedVLAN
2.4 GHz and 5 GHz radios
(These settings apply to all user WiFi networks.)
2.4 GHz radio: 20 MHz
5 GHz radio: 40 MHz
Channel HT mode
Automatic (Auto)Radio transmission power
The available channels and the default channel depend on the configured region
and country.
Channel
AutomaticBit rate
64 for each radio
128 for the AP
Client limits
EnabledMulticast to unicast stream
conversion
Enabled11ax mode
DisabledBand steering
NoneWiFi on/off schedule
System
Obtained automatically from the default NTP serverDate and time settings
EnabledLog
DisabledRemote log
User Manual125Factory Default Settings and
Technical Specifications
Essentials WiFi 6 AX1800 Dual Band Access Point Model WAX214v2
To Next Page
Loading...
