Mount the AP to a solid wall
CAUTION: Make sure that the wall is not damaged. For example, water damage can
destroy drywall.
To mount the AP to a solid wall:
1.
Place the mounting plate on the wall. The latch on the mounting plate must face
downward.
2. Mark the wall where the mounting holes are.
3. Using a 3/16 in. (4.7 mm) drill bit, drill holes in the wall.
4.
Tap each anchor into the wall with a soft mallet until the anchors are flush with the
wall.
Note: Unless you insert the screws into a wall stud, do not insert the screws into the
wall without anchors.
5. Use the two Phillips head screws to attach the mounting plate to the wall.
6. Connect cables to the AP.
User Manual129Mount the AP to a Wall or
Ceiling
Essentials WiFi 6 AX1800 Dual Band Access Point Model WAX214v2
To Next Page
Loading...
