NETGEAR WAX214v2 - Connect to the AP over the LAN and log in for the first time

5. Wait one minute until the AP completes its restart.
6.
If you were disconnected because the AP restarted, log back in to the management
WiFi network.
The summary page displays again.
7. Click the Done button.
You are done. The AP is connected to the network and ready to use. You can now
connect a computer or mobile device to the user WiFi network that you just set up,
using the WiFi password that you just defined.
8.
(Optional) To continue to configure the AP for your network and environment, do
the following:
a. Log in again.
If you are still connected to the management WiFi network but the login page
does not display, in the address field of your web browser, enter
https://www.aplogin.net.
If your browser display a security warning, proceed, or add an exception for the
security warning. For more information, see kb.netgear.com/000062980.
b.
In the AP Login Password field, enter your new password for the device UI, and
click the LOGIN button.
The Dashboard page displays.
You can now configure the AP.
Connect to the AP over the LAN and log in for the first time
The following procedure assumes that your network includes a DHCP server (or router
that functions as a DHCP server) and that the AP and your computer are on the same
LAN. By default, the AP functions as a DHCP client and receives an IP address from a
DHCP server.
User Manual20Installation and Initial Login
Essentials WiFi 6 AX1800 Dual Band Access Point Model WAX214v2