EasyManuals Logo

NETGEAR WAX214v2 User Manual

NETGEAR WAX214v2
135 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
4. Select Management > Management > Time Zone.
The page that displays shows the Date and Time Settings section and the Time Zone
section.
5. In the Auto Reboot Settings section, select the Status Enable radio button.
6.
Select one or more check boxes for the days on which you want the AP to
automatically restart.
7.
In the fields under the days, use the 24-hour clock format to enter the hour in the
left field (for example, enter 23 for 11 p.m.) and the minutes in the right field (for
example, enter 30 for 11:30 p.m.).
8. Click the Apply button.
Your settings are saved.
Reset the AP to factory default settings
Under some circumstances (for example, if you lost track of the changes that you made
to the configuration of the AP or you move the AP to a different network), you might
want to erase the configuration and reset the AP to factory default settings (see Factory
default settings on page 124).
If you do not know the current IP address of the AP, first try to use an IP scanner
application to detect the IP address before you reset the AP to factory default settings.
You can use either the physical Reset button on the back panel of the AP (see Hardware
interfaces on page 10) or the software Reset button in the device UI.
After you reset the AP to factory default settings, the default settings are as follows:
The LAN IP address is https://192.168.0.100, which is the same as
https://www.aplogin.net.
The AP’s DHCP client is enabled,
The management WiFi network is shown in the format
WAX214XXXXXX-CONFIG-ONLY, where XXXXXX is customized to every device
(based on the last six digits of the MAC address).
The default password for WiFi access to the management WiFi network is a unique
WiFi password that is printed on the AP label.
For a list of factory default settings, see Factory default settings on page 124.
CAUTION: Resetting to factory defaults erases all settings that you configured in the
AP.
User Manual91Maintain the AP
Essentials WiFi 6 AX1800 Dual Band Access Point Model WAX214v2

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR WAX214v2 and is the answer not in the manual?

NETGEAR WAX214v2 Specifications

General IconGeneral
2.4 GHzYes
MIMO typeMulti User MIMO
Networking standardsIEEE 802.11a, IEEE 802.11ac, IEEE 802.11ax, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Ethernet LAN data rates10, 100, 1000 Mbit/s
Maximum data transfer rate1201 Mbit/s
Maximum data transfer rate (2.4 GHz)573.5 Mbit/s
PlacementCeiling, Wall
Product colorWhite
Security algorithmsSSID, WPA2, WPA3
Number of SSID supported4
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Ethernet LAN (RJ-45) ports1
Antenna typeInternal
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)5 - 95 %
Weight and Dimensions IconWeight and Dimensions
Width196 mm
Height44.4 mm
Weight523 g

Related product manuals