5. Select the LED tab.
The LED Control page displays.
6.
To control the Power LED, select one of the following Power radio buttons:
•
Enable: The Power LED is enabled. This is the default setting.
•
Disable: The Power LED is disabled and turned off.
7.
To control the LAN, 2.4 GHz WLAN, and 5 GHz WLAN LEDs, select one of the
following Other radio buttons:
•
Enable: The LAN, 2.4 GHz WLAN, and 5 GHz WLAN LEDs are enabled. This is
the default setting.
•
Disable: The LAN, 2.4 GHz WLAN, and 5 GHz WLAN LEDs are disabled and
turned off.
8. Click the Apply button.
Your settings are saved.
Restart the AP from the device UI
You can use the device UI to restart the AP. This is useful if the AP is installed at a location
that is not easy to reach.
To restart the AP from the device UI:
1.
Launch a web browser from a computer or tablet that is directly connected over WiFi
to the AP or connected to the same network as the AP.
2. Enter the IP address that is assigned to the AP.
If you are directly connected to the management WiFi network, you can enter
https://www.aplogin.net.
A login page displays.
If you do not know the IP address, see Find the IP address of the AP on page 24. For
more information about the management WiFi network, see Management WiFi
network on page 43.
If your browser displays a security warning, you can proceed, or add an exception
for the security warning. For more information, see kb.netgear.com/000062980.
3. Enter the AP login password and click the LOGIN button.
The AP login password is the one that you specified the first time you logged in to
the AP. The password is case-sensitive.
User Manual89Maintain the AP
Essentials WiFi 6 AX1800 Dual Band Access Point Model WAX214v2
To Next Page
Loading...
Need help?
General
Weight and Dimensions
