Do not install the antenna and IPmodem when there is a risk of
thunderstorm or lightning activity in the area;
To prevent electrical shock, do not connect the plug into an extension
lead (with 1 or more sockets) or other outlet unless the plug can be fully
inserted with no part of the pins exposed;
The in-line power supply input power cord must be connected to a
properly grounded three-prong AC outlet. Do not use adapter plugs or
remove the grounding prong from the plug;
Do not use the in-line power supply power cord when damaged in any
way.
Cautions
A caution is defined as a procedure or practice that, if not correctly
followed, could result in equipment damage or destruction.
Always observe the following cautions. Not following these
cautions will cause the warranty to be invalid.
Always use the in-line power supply with the IPmodem. Using a different
power supply may cause equipment damage;
To ensure regulatory and safety compliance, use only the provided power
and interface cables or cables which conform to the specifications within
this manual;
Do not open the unit. Do not perform any actions other than those
contained in the installation and troubleshooting instructions. Refer all
servicing to qualified service professionals;
Avoid damaging the IPmodem with static electricity, by first touching the
coaxial cable connector when it is attached to the earth grounded coaxial
cable wall outlet. Always first touch the coaxial cable connector on the
IPmodem when you are disconnecting or re-connecting your Ethernet
cable from the IPmodem or your computer;
To prevent overheating, do not block the ventilation holes on the sides
and top of the IPmodem;
Only wipe the unit with a clean, dry cloth. To avoid equipment damage,
never use fluids or similar chemicals. Do not spray cleaners directly on
the unit. Do not use compressed air/gas to remove dust;
To Next Page
Loading...
