The user should install an AC surge arrestor in the AC outlet to which this
device is connected. This avoids damaging the equipment by local
lightning strikes and other electrical surges;
Due to the wind pressure equivalent area of the antenna, do not make an
installation in bad weather conditions;
Secure tight all parts to avoid any potential danger to persons and
surroundings;
If faced with a critical situation in which personal safety is in jeopardy, do
not try to keep hold of the antenna;
For safety reasons, ensure that you are not near any power line;
Make sure a minimum distance of 6 metres (20 feet) separates the
antenna from any power line;
Before digging, in case of need for a penetrating antenna mast, contact
your local authority to check for information regarding any underground
cables and (power) utility line(s).
Notices
This product was qualified under test conditions that included the use of
the supplied cable between the components. To be in compliance with
regulations, the user must use this cable – or equivalent – and install it
properly;
Different types of cord sets may be used for connections to the main
supply circuit. Use only a main line cord that complies with all product
safety requirements of the country of use;
Installation of this product must be in accordance with national wiring
codes.
In some countries, authorisation is needed for satellite reflector
installation. Call your local authorities in case of doubt.
To Next Page
Loading...
