Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A
Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
Installation and System Design Guide 185
Issue Number: 1
7.12 Backing up the drive parameter set
The E300 Elevator drive parameters can be backed up using either of the following two methods. Both the Elevator Connect PC tool and the NV
Media Card allow the complete drive parameter set to be saved. Once the parameter set is saved, this can be re-programmed if required to the same
drive or cloned to other drives.
7.13 NV Media Card
The NV Media Card used for backing up the drive parameters can be either a SMARTCARD or an SD card Adaptor with SD card.
Blocked elevator car release Elevator function to release blocked Elevator car, safety gear engaged
Terminal control error detection
Terminal control error detection Speed selection, Direction inputs, Safe Torque Off (STO) Fast
disable
Speed error Speed error detection for Open-loop and RFC-A, RFC-S operating modes
Distance error Distance error detection for RFC-A, RFC-S operating modes
Lifetime control Internal monitoring, optimisation of control to increase drive lifetime
Optimisation
Profile
Multiple profile jerks, Jerk 1 to Jerk 4
Standard Acceleration and Deceleration rates
Flexible fixed, multiple user defined deceleration rates
Creep to floor stop Deceleration rate and Jerk
Start optimisation
Start optimisation Speed, Jerk and Time option for RFC-A and RFC-S permanently enabled for
Open-loop control
Speed loop gains (RFC-A, RFC-S)
Multiple speed loop Kp, Ki gains (Start, Run, Stop)
Default setting uses Kp, Ki Start and Run gains only
Start locking Start lock position control to support high performance without roll back
Current loop gains (OL, RFC-A, RFC-S)
Multiple current loop Kp, Ki gains (Start, Run, Stop)
Default setting uses Kp, Ki Start and Run gains only
Control loop filters (RFC-A and RFC-S)
Multiple current control loop filters (Start, Run, Stop)
Default setting uses Start and Run current loop filters only
Position feedback filter (RFC-A, RFC-S)
Position feedback filter for closed loop RFC-A and RFC-S modes to overcome position feedback
induced noise, installation, EMC and quantisation
When installing and removing the NV Media Card beware of possible live power terminals which could result in a safety hazard and
electric shock. All safety cover must be installed and power terminals shrouded to avoid the risk of death or serious injury.
When reading a parameter set from a SMARTCARD, SD card to the drive during setup this can result in the control I/O firstly defaulting
and then changing to the configuration on the SMARTCARD,SD card. Ensure during this process all control terminals are removed from
the drive and any SI-I/O module to prevent uncontrolled operation of external devices and the risk of damage to the system.
To Next Page
Loading...
