Nidec E300 Series - Menu N: Storage

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
Installation and System Design Guide 235
Issue Number: 1
8.13 Menu N: Storage
Menu N Storage provides user parameters for the media card option on the Elevator drive, which supports both SMARTCARDS and SD Cards (FAT
formatted SD card).
The NV Media Card option on the Elevator drive supports the following actions:
• Read - Allows the transfer of existing parameter data to the Elevator drive from the media card.
• Program - Allows the transfer of parameter data from the Elevator drive to a parameter file on the media card with file identification number 1.
• Auto - Allows the transfer of parameter data from the Elevator drive to a parameter file on the NV Media Card with file identification number 1.
In addition any parameter in User Menu A changed via the keypad is saved both to the drive memory, and the parameter file on the NV Media
Card with file identification number 1
• Boot - Allows the transfer of parameter data from the Elevator drive to a parameter file on the NV Media Card with file identification number 1.
In addition any parameter in User Menu A changed via the keypad is saved both to the drive memory, and the parameter file on the NV Media
Card with file identification number 1. When the Elevator drive is powered up it detects which option modules are fitted before loading parameters
from a media card which has been set up for Boot.
The NV Media Card can be used as a means for storing the complete drive parameter set following commissioning, set-up and tuning, used during
multiple drive system installation, copying parameters across multiple drives, or used to set-up a replacement Elevator drive. The NV Media Card can
be used to store drive parameter sets from the Elevator drive in data blocks 001 to 499 supporting multiple drives with different ratings and parameter
sets.
Parameter
Range(Ú) Default(Ö)
Type
Open-Loop RFC-A RFC-S Open-Loop RFC-A RFC-S
N01 Parameter Cloning
None (0), Read (1), Program (2),
Auto (3), Boot (4)
None (0) RW Txt NC US
N02
Media Card File Previously
Loaded
0 to 999 0 RO Num NC PT
N03 Media Card File Number 0 to 999 0 RW Num
N04 Media Card File Type
None (0), Open-loop (1), RFC-A (2), RFC-S (3),
Regen (4), User Prog (5), Option App (6)
RO Txt ND NC PT
N05 Media Card File Version 0 to 9999
RO Num ND NC PT
N06 Media Card File Checksum -2147483648 to 2147483647
RO Num ND NC PT
N07 Media Card Create Special File 0 to 1 0 RW Num NC
N08 Media Card Type None (0), SMART Card (1), SD Card (2)
RO Txt ND NC PT
N09 Media Card Read-only Flag Off (0) or On (1)
RO Bit ND NC PT
N10
Media Card Warning
Suppression Flag
Off (0) or On (1)
RO Bit ND NC PT
N11
Media Card File Required
Version
0 to 9999
RW Num ND NC PT
RW Read / Write RO Read-only Bit Bit parameter Txt Text string Date Date parameter Time Time parameter
Chr
Character
parameter
Bin Binary parameter IP IP address Mac MAC address Ver Version number SMP
Slot, menu,
parameter
Num Number parameter DE Destination ND No default value RA Rating dependent NC Non-copyable PT Protected
FI Filtered US User save PS Power-down save