Installation
2-68 42-02-2M01 A1
Adjust Brake to 125% of Full Load
1. Bring the car to the bottom landing.
2. Place weights in the car to 2/3 of contract load.
3. Add an additional 50 or 100 pounds.
4. Move the car up a short distance on Inspection.
5. Run the car down and trip the stop switch.
6. Adjust the brake if it does not hold.
7. Repeat until the brake is holding 125% of full load capacity.
8. Remove test weights from car.
Keep the car near the bottom floor as it is likely to slide through the brake onto the buffers if
brake spring tension is inadequate.
Traction Auxiliary Power Supply
If you are installing the TAPS (Traction Auxiliary Power Supply) from MCE to provide emer-
gency power for passenger rescue in the event of commercial power loss, follow instructions in
the TAPS manual delivered with the unit.
Installation Review
• Carefully review MCE job prints and job requirements.
• Ensure that all equipment has been correctly installed and connected.
• Verify that all jumpers placed during installation have been removed and replaced with
permanent connections.
• Verify that all safety equipment is installed and is functioning properly.
• Ensure that Inspection faults are no longer on bypass in the Controller System Menu (F3
function switch on MPU board)
At this point, controller and related installation should be complete. The car should be running
safely on Inspection operation from the cartop and/or the machine room. The next section will
describe:
• Learning the hoistway
• Setting controller parameters
• Setting drive parameters
•Performance Adjustment
• Final Test
To Next Page
Loading...
